.status (show the debugger status)

Description of the '.status' command in HyperDbg.

Command

.status

Syntax

.status

Description

Shows the connection status of the HyperDbg's Connection.

Parameters

None

Examples

The following example shows the status of remote debugging.

HyperDbg (192.168.1.10:50000)> .status
remote debugging ('vmi mode'), ip : 192.168.1.10:50000

IOCTL

None

Remarks

In HyperDbg, 'status' and '.status' commands are different if you connected to a remote debugger, but if you try to debug your system locally, then these commands are the same.

If you execute the '.status' command, it shows the current debugger's status (the debuggee's IP address). If you execute the 'status' command, it will be executed in the debuggee and shows the debuggee's state (not debugger).

Requirements

None

status (show the debuggee status)

Last updated